Mount Vernon Drywall Co. hangs and finishes garage ceilings to the fire rating and durability an attached garage demands. Where a garage sits beneath or beside living space, code requires a fire-rated separation, which means Type X 5/8" board installed to a tested assembly. A garage also swings through moisture and temperature far more than a heated room, so board choice and fastening matter more than they would in a bedroom. We build the ceiling to pass inspection and to hold a flat, clean plane despite the conditions.
When a garage shares a ceiling with living space, the building code calls for a fire-rated separation, typically Type X 5/8" board on the ceiling and the common wall. We hang the specified layers, use fire-rated joint treatment, and finish so the assembly performs to its listed rating. Getting the board type and the details right is what carries a garage ceiling through inspection.
Garage ceilings often span wide bays with little intermediate support, and standard half-inch board can droop between the joists over time. We specify sag-resistant ceiling board or 5/8" panels, which hold a flat plane far better across the span. Correct board choice is the biggest factor in a garage ceiling that does not develop waves or seam ridges.
Uninsulated garages cycle through humidity and temperature far more than a conditioned room, which is hard on both fasteners and finish. We fasten to tight spacing so the board stays snug to every joist and, in damp bays, hang moisture-resistant board that stands up to the swings. That specification work prevents nail pops and seam cracking down the line, then we tape and finish the field to a clean Level 4.
Garages across Mount Vernon, NY and Yonkers, Tuckahoe, Eastchester, Tarrytown, and White Plains get their ceiling drywall finished by Mount Vernon Drywall Co.