Mount Vernon Drywall Co. hangs and finishes ceilings that stay flat and crack-free for the long term. A ceiling is the hardest surface in any home to get right, because gravity works against the board and every seam is exposed under overhead light. We frame or fur out as needed, hang the correct-weight panel on tight fastener spacing, and finish the field to a smooth, uniform plane. Whether it is a new build-out or a fresh ceiling in an existing room, we install it so the result reads as one continuous surface.
Standard half-inch board can droop between joists over time, especially on wider spacing or under the weight of insulation. For ceilings we specify sag-resistant panels or 5/8" board, which hold a flat plane far better across the span. Correct board choice up front is the single biggest factor in a ceiling that does not develop waves or seam ridges down the road.
A durable ceiling starts with fasteners driven to the right depth on tight spacing so the board is pulled snug to every joist. Where the framing is uneven, we shim or install furring strips to build a true plane before a panel goes up. On leak-prone or high-moisture ceilings we hang moisture-resistant board so the surface stands up to the conditions.
Butt joints on a ceiling are the most likely place to telegraph, so we back-block or stagger them and float the compound wide to bury the buildup. The field is taped with paper or mesh, coated in successive passes, and sanded to a smooth Level 4 or, on request, a full Level 5. The finished ceiling is primed and ready for your paint.
If you need ceiling drywall installation in Mount Vernon, NY, our crews also cover Tuckahoe, Yonkers, Eastchester, White Plains, Hartsdale, and Mamaroneck.